Focus ZTS L4-2.0L DOHC VIN 3 (2001)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Control Unit (HCU)
Removal
All Vehicles
1. CAUTION: If brake fluid is spilt on the paint work, the effected area must be immediately washed down with cold water.
Disconnect the battery ground cable.
2. Disconnect the electrical connection from the filler cap.
1. Pull back the tab.
2. Depress the clips.
3. Disconnect the electrical connector.
3. CAUTION: Make sure the filler cap does not become contaminated.
Remove the brake fluid reservoir filler cap.
4. Loosen the wheel nuts of the front wheels.
5. Raise and support the vehicle.
6. Remove the front wheels.
7. Loosen the bleed nipple.
1. Remove the dust cap.
2. Loosen the bleed nipple.
8. NOTE: Carry out this process on both the front brake lines.