Focus ZTS L4-2.0L DOHC VIN 3 (2001)
2. Remove the tripod.
^
Remove the snap ring.
3. Remove the tripod.
^
Using the special tool remove the tripod.
^
Remove the boot.
4. Detach the boot at the wheel end.
^
Separate and discard the clamping straps.
^
Remove the boot over the transaxle side.
^
Remove the accessible grease.
Assembly
CAUTION: The inner joint must not be bent at more than 18 degrees; the outer joint must not be bent at more than 45 degrees.
1. NOTE: Install the wheel-side boot over the transaxle side.
NOTE: To determine the amount of grease, refer to Specifications for fill capacities.
Install the boot at the wheel end.
^
Inject the specified amount of grease into the outer joint.