Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
^
Prevent turning using the special tool.
5. NOTE: Loosening sequence.
Unscrew the bolts of the camshaft bearing caps evenly in several stages two turns at a time.
^
Remove the oil seals.
^
Remove the camshaft
Installation
1. NOTE: Identification numbers are provided on the outer face of the camshaft bearing caps.
Apply sealant to camshaft bearing cap numbers 0 and 5 in the areas shown.
2. Turn the crankshaft to approximately 60 degrees before TDC on cylinder number 1.
3. NOTE: Lay the camshaft in place so that none of the cams is at full lift.
Lubricate the camshaft and camshaft bearing cans with engine oil.