Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Non Functional
IGNITION LOCK CYLINDER - NON FUNCTIONAL
Removal and Installation
1. Remove the steering wheel.
2. Remove the passive anti-theft transceiver.
3. Draw a line through the middle of the ignition lock cylinder face 90 degrees to the key slot.
4. Mark a point on the line 3 mm (0.11 in) down from the slot which is just beyond the center of the lock face.
5. Drill a 4 mm (0.15 in) pilot hole 3 mm (0.11 in) deep.
6. Drill a 10 mm (0.39 in) hole 35 mm (1.37 in) deep.
7. Remove the lockbar from the side of the hole.