Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
1. Remove the bump stop.
2. Install the spacer between the rear lower arm and the crossmember making sure the spacer is in a vertical plane.
Wagon
6. NOTE: Do not fully tighten the rear lower arm to wheel knuckle bolt at this stage.
Attach the rear lower arm to the wheel knuckle.
7. Fabricate a 20 mm wide by 157 mm long spacer.
8. Using a suitable wooden block and a suitable transmission jack, raise the suspension to the design height setting.
^
Position the wooden block and transmission jack as shown.
