Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
5. CAUTION: Support the halfshaft. The inner joint must not be bend more than 18 degrees. The outer joint must not be bent more than 45 degrees.
Detach the halfshaft from the transaxle and secure it to one side.
-
Allow the oil to drain into a suitable container.
6. Remove the halfshaft seal.
Installation
1. Using the special tools, install the halfshaft seal.
2. CAUTION: Support the halfshaft. The inner joint must not be bent more than 18 degrees; the outer joint must not be bent more than 45 degrees.
CAUTION: Do not damage the halfshaft seal.
NOTE: Install a new halfshaft bearing cap and locknuts.
Attach the halfshaft to the transaxle.
-
Install the center bearing cap and locknuts.
3. Attach the lower arm to the wheel knuckle (left hand side shown).
4. Install the wheel and tire.
