Freestar V6-4.2L VIN 2 (2004)
1. Remove the five screws and the floor duct.
2. Remove the seven screws and the heater core cover.
-
Detach the wire harness.
3. Remove the heater core.
Item 17: Evaporator Core Removal Note
1. Remove the eleven screws and the evaporator core cover.
2. Remove the dash panel seal and the evaporator core.
Item 18: Air Inlet Duct Removal Note
1. Remove the air inlet duct.
1
Disconnect the air inlet mode door actuator electrical connector.
2
Remove the four screws and the air inlet duct.
INSTALLATION
1. To install, reverse the removal procedure.
2. Lubricate the refrigerant system with the correct amount of clean PAG oil.
3. Fill the engine coolant level.
4. Evacuate, leak test and charge the refrigerant system.
