Freestar V6-4.2L VIN 2 (2004)
INITIALLY CONNECTED TO THE DLC.
Connect WDS to vehicle.
Select "16 pin", select "All others, except those below", press TICK.
Screen shows installation of cable, press TICK.
Screen shows to turn ignition ON. DO NOT TURN IGNITION ON. Press TICK.
Screen shows progress bar, then screen tells you "No communication can be established with the PCM" and asks you if you want to retry? Select
"NO". With the ignition key still OFF, press TICK.
Screen shows to turn ignition ON. Turn ignition on, press TICK.
Screen shows "The PCM installed to this vehicle is blank". You will be prompted to select VIN from a list of previous sessions. Press TICK.
When previous sessions are shown select "None of the above".
Screen shows 'To enable WDS to reprogram the PCM with the correct calibration", enter one of the following: Vehicle Calibration # (7 digits),
Tear Tag # (4 digits), or PCM part #, press TICK.
Highlight the box next to the selection chosen, and enter ONLY ONE of the selections listed above. Press TICK.
Follow and answer correctly all remaining screens.
Once PCM is reprogrammed communication should be reestablished and PATS system can be reset (if necessary) as per Section 419-01 of the
WARRANTY STATUS: Information Only