Freestar V6-4.2L VIN 2 (2004)
1. WARNING: Check the side air bag deployment chute and clips for damage. The deployment chute and clips must not be repaired. If
there is any damage to the deployment chute or clips, the seat back trim cover and deployment chute must be installed new as a unit.
Position the deployment chute and clips through the backrest foam pad.
2. WARNING: If the air bag deployment chute is not properly positioned and completely closed, the side air bag may not deploy properly.
Position the air bag deployment chute.
1
Insert the outboard side of the air bag deployment chute between the seat back pad and the side air bag module, pulling it around the outboard
side of the seat back frame.
2
Insert the inboard side of the air bag deployment chute between the seat back pad and the side air bag module from the inboard side of the seat
back.
3. WARNING: If the air bag deployment chute is not properly positioned and completely closed, the side air bag may not deploy properly.
Attach the deployment chute clips and hook and loop strips.
-
The side air bag deployment chute must encircle the side air bag module, going completely around the side air bag module and the side of the
seat back frame.
-
Align the side air bag deployment chute to the side air bag module, making sure it covers the length, but not the top or bottom, of the side air
bag module.
4. Roll the seat backrest trim cover down and reattach the lower J-clips.
-
Make sure any necessary wire harnesses, connectors or ducts are through the trim cover openings.
Item 16: Climate Control Seat Duct Installation Note
