Freestar V6-4.2L VIN 2 (2004)
Windshield: Service Precautions
CAUTION:
-
Cover the instrument panel in order to prevent possible damage.
-
Care must be used to avoid scratching the pinch weld.
-
If equipped, care must be taken to avoid damage to the headliner wiring harness.
-
After installing the new windshield glass, the vehicle should not be driven until the urethane adhesive has cured. The curing time at
temperatures above 13°C (55°F) and relative humidity above 50% is 12-24 hours. (Refer to the Essex drive away chart for the cure times
as the temperatures and humidity vary). Inadequate curing of the urethane adhesive may adversely affect the strength of the urethane
adhesive bond.
-
Care must be taken to avoid scratching the pinch weld.
-
All rust found on the pinch weld must be removed and the pinch weld restored to OEM specifications. If surface rust is found, remove
completely down to clean, bare metal. Prime pinch weld metal with an OEM-recommended curing automotive paint primer and allow to
cure. If rust has penetrated through the pinch weld metal, repair the pinch weld sheet metal at a body shop before proceeding.
-
Open the windows to prevent the windshield glass from being pushed out by air pressure if a door is closed.
