Freestyle AWD V6-3.0L VIN 1 (2005)
Using a 5-mm (3/16-inch) drill, remove the 2 rivets and the ECU from the seat cushion frame bracket.
Seats with an OCS service kit
13. NOTE: Make note of the opening that the OCS service kit components are being fed through on the seat cushion support assembly for installation
purposes.
Remove the OCS service kit from the seat cushion frame.
-
Remove any tie straps securing wire harnesses or electrical connectors.
-
Feed the hose, pressure sensor, wire harness, electrical connector and electronic control unit through the seat cushion frame support assembly.
Heated seats
14. Release the tab in the slot and slide the heated seat module off the bracket. Disconnect and remove the heated seat module.
Seats with power recline
15. Disconnect the power seat backrest adjust motor electrical connector.
16. Drive out the 2 large roll pins.
17. Remove the 3 bolts and the power seat backrest adjust motor assembly.
Vehicles with manual recline seats
18. Drive out the 2 large roll pins and remove the manual seat backrest adjuster.
All vehicles
19. Remove the seat wire harness.
20. Remove the hog rings and cushion trim cover.
Assembly
Heated seats
1. Seats receiving a new OCS service kit, install the new cushion heated seat element onto the new cushion foam pad.
All seats