Freestyle AWD V6-3.0L VIN 1 (2005)
4. Connect the electrical connector to the safety belt retractor pretensioner.
5. Obtain 2 wires (20 gauge minimum) at least 6.1-meters (20-feet) long and attach one end of each wire to the safety belt pretensioner wires.
6. Obtain 2 wires (20 gauge minimum) at least 6.1-meters (20-feet) long and attach one end of each wire to the safety belt pretensioner wires.
7. Position the safety belt retractor pretensioner assembly on a flat surface in an open outdoor area so that moveable parts do not contact the support
surface.
8. Remain at least 6.1 meters (20 feet) away from the safety belt retractor pretensioner assembly.
9. Deploy the safety belt retractor pretensioner by touching the other ends of the 2 wires to the terminals of a 12-volt battery.
10. To allow for cooling, wait at least 10 minutes before approaching the deployed safety belt retractor pretensioner assembly.
11. Dispose of the deployed safety belt retractor pretensioner assembly in the same manner as any other part to be scrapped.