Fusion L4-2.3L VIN Z (2006)
2. Install the transmission-mounted fluid cooler tubes.
^
Tighten to 10 Nm (89 inch lbs.).
3. Position the transmission fluid cooler tubes in place and install the retainer.
4. Install the transmission fluid cooler tubes in the retainers.
5. NOTE: The power steering hose is routed between the 2 transmission fluid cooler hoses.
Position the transmission fluid cooler hoses in place.
6. CAUTION: Use care not to over stretch or extend the hose clamps.
CAUTION: The hose clamps are held on the hose with a special epoxy. Damage may occur to the hose if the clamp is removed from the hose. If
the clamp or hose is damaged, replace the entire fluid cooler tube.
