Fusion L4-2.3L VIN Z (2006)
1. Install a new stub shaft circlip.
2. Insert the halfshaft into the wheel hub.
3. NOTE: After insertion, pull the halfshaft inner end to make sure the circlip is locked.
Push the stub shaft into the transmission so the circlip locks into the differential side gear.
4. Install the splash shield and pushpins.
5. Rotate the knuckle into position.
6. Install the lower control arm bolt and nut
^
Tighten to 103 Nm (76 ft. lbs.).
7. Install the bolt connecting the damper fork to the lower control arm.
^
Tighten to 109 Nm (80 ft. lbs.).
