| Removal and Installation Removal | | -
Remove the heater/evaporator housing.
For additional information, refer to: Heizungs-/Verdampfergehäuse (412-02A, Removal and Installation).
| | | -
Remove the bracket for the coolant pipes. | | | -
Remove the heater/evaporator housing gasket. | | | -
Remove the right-hand bolts of the fresh air duct. | | | -
Unclip the operating cable of the left-hand air inlet flap from the heater/evaporator housing. | | | -
Detach the left-hand air inlet flap from the fresh air duct and lay it to one side. - Remove the fresh air duct.
| | | -
Remove the pollen filter housing cover. | | | -
Remove the bolts of the lower heater/evaporator housing. | | | -
Remove the lower heater/evaporator housing. | | | -
Remove the upper bolts of the heater/evaporator housing. | | | -
Remove the front bolts of the heater/evaporator housing. | | | -
Remove the rear bolts of the heater/evaporator housing. | | | -
Separate the heater/evaporator housing. | Installation | | -
To install, reverse the removal procedure. | | |
