ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Battery Tray > < Battery Disconnect and Connect

Fusion 2002.75 (06.2002-)

Battery, Mounting and Cables - Battery to Starter Motor Solenoid Cable—1.4L Duratec-16V (Sigma)/1.6L Duratec-16V (Sigma) Fusion 2002.75 (06/2002-)
Removal and Installation

Removal

  1. Disconnect the battery ground cable.
    For additional information, refer to Battery Disconnect in this section.

  1. Open the battery positive terminal cover.

  1. Disconnect the battery positive cables.

  1. Detach the battery to starter motor solenoid cable from the retaining clip on the wiring harness cover.

  1. Remove the protective cap and disconnect the generator electrical connector.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Detach the battery to starter motor solenoid cable from the retaining clip.

  1. Disconnect the starter motor solenoid cable electrical connector.

  1. Disconnect the ignition switch to starter motor solenoid and battery to starter motor solenoid cables (oil filter shown removed for clarity).

  1. Detach the battery to starter motor solenoid cable from the retaining clip on the intake manifold.
  1. Remove the battery to starter motor solenoid cable.

Installation

  1. To install, reverse the removal procedure.

Battery Tray > < Battery Disconnect and Connect