Fusion AWD L4-2.3L (2008)
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Remove the brake fluid reservoir.
2. If equipped with a manual transmission, disconnect the clutch master cylinder feed hose.
^
Plug the clutch master cylinder feed hose.
3. Disconnect the brake tube fittings, plug the brake tubes and the brake master cylinder ports.
^
To install, tighten to 17 Nm (13 lb-ft).
4. Remove the 2 brake master cylinder nuts.
^
To install, tighten to 25 Nm (18 lb-ft).
5. Remove the brake master cylinder.
6. To install, reverse the removal procedure.
^
Bleed the master cylinder.
^
If equipped with a manual transmission, bleed the clutch master cylinder.
