Fusion AWD V6-3.0L (2009)
NOTE: Carrying out Programmable Module Installation (PMI) will not enable the 911 assist option that is disabled. The RCM and Accessory Protocol
Interface Module (APIM) must be configured correctly to fully support 911 assist functionality.
1. If installing a new RCM, carry out the steps necessary to prepare for Programmable Module Installation (PMI).
2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint
System (SRS) Depowering and Repowering in the General Procedures portion.
3. Remove the 2 RH side RCM bolts.
-
Position the carpet back at the RH side of the center tunnel area under the instrument panel and remove the 2 bolts.
4. Disconnect the large RCM electrical connector.
1. Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
2. Pull out and disconnect the RCM electrical connector.
5. Remove the RCM.
1. Disconnect the small RCM electrical connector.
2. Remove the LH bolt.
3. Remove the RCM.
Installation
1. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
Position the RCM.
-
Install the 2 RH side RCM bolts.
-
Tighten to 12 Nm (106 lb-in).
-
Position the carpet back at the RH side of the center tunnel area under the instrument panel.
2. Install the RCM.
-
Install the LH side RCM bolt.
-
Tighten to 12 Nm (106 lb-in).
-
Connect the small RCM electrical connector.
3. Make sure the large RCM connector position assurance lever is in the full release position before attempting to connect the connector.