Fusion AWD V6-3.0L (2009)
lever or shaft may occur.
Connect the selector lever cable end.
7. Install the ACL assembly.
8. Connect the battery ground cable.
9. Carry out the TCM initial learning procedure. For additional information, refer to Transmission Control Module (TCM) Initial Learning See:
Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Procedures/Aisin AW21/Transmission Control Module
(TCM) Initial Learning.
10. Check for correct vehicle operation.
FNR5
Transmission Control Module (TCM)
Removal
1. NOTE: The Transmission Control Module (TCM) is located under the LH side of the instrument panel.
Disconnect the 2 electrical connectors.
