Fusion AWD V6-3.5L (2010)
5. Remove the RH recliner outboard cover in the following sequence.
1. Remove the scrivet.
2. Release the clips at the front and rear of the recliner cover.
3. Remove the RH recliner outboard cover.
6. Separate the cable at the RH recliner in the following sequence.
1. Release the cable housing from the RH recliner.
2. Separate the cable from the RH recliner.
RH recliner only
7. Remove the 2 recliner-to-cushion frame bolts, 2 recliner-to-backrest frame bolts and remove the RH recliner.
-
To install, tighten to 55 Nm (41 lb-ft).
LH recliner only
8. Remove the LH recliner outboard cover in the following sequence.
1. Remove the scrivet.
2. Release the clips at the front and rear of the recliner cover.
3. Separate the side air bag module and heated seat (if equipped) wire harnesses from the recliner cover.
4. Remove the LH recliner outboard cover.
9. Release the cushion trim cover retainer from around the safety belt buckle and separate the hook-and-loop strip.
10. Separate the cable at the LH recliner in the following sequence.
1. Separate the cable from the LH recliner.
2. Squeeze the cable housing tabs together and separate from the LH recliner.
11. Remove the 2 recliner-to-cushion frame bolts, 2 recliner-to-backrest frame bolts and remove the LH recliner.
