Fusion AWD V6-3.5L (2010)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor
Removal and Installation
1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
2. Disconnect the Camshaft Position (CMP) sensor electrical connector.
3. Remove the bolt and the CMP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
4. NOTE: Lubricate the CMP sensor O-ring seal with clean engine oil.
To install, reverse the removal procedure.
