Fusion AWD V6-3.5L (2010)
RH halfshaft
12. Use a brass drift to strike the RH halfshaft in the indicated area and separate the RH halfshaft from the intermediate shaft.
LH halfshaft
13. Using the Halfshaft Remover and Slide Hammer, separate the halfshaft from the transmission.
RH and LH halfshafts
14. Position the damper fork and halfshaft forward of the front lower arm and remove the halfshaft.
15. Remove and discard the stub shaft circlip (LH) or the intermediate shaft circlip (RH).
Installation
RH and LH halfshafts
1. NOTICE: Make sure to install the correct circlip for each application. Failure to use the correct diameter circlip may result in shaft
removal concerns or shaft damage during vehicle operation.
Install a new circlip.