Fusion AWD V6-3.5L (2010)
Seals and Gaskets: Service and Repair
Halfshaft Seal
Removal and Installation
NOTICE: New halfshaft oil seals should be installed any time the halfshafts are removed. Failure to install new halfshafts seals may result in
transaxle oil leak(s) and damage to the transmission may occur.
1. Remove the transaxle drain plug and drain the fluid.
2. Remove the RH intermediate shaft or LH halfshaft. For additional information, refer to Drive Axles, Bearings and Joints.
3. Using the Slide Hammer with the Stator Case Bearing Remover, remove the RH intermediate shaft oil seal or the LH halfshaft oil seal.
