Fusion FWD L4-2.3L (2008)
Drive Belt Tensioner: Service and Repair
Accessory Drive Belt Tensioner
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 screws and position the RH fender splash shield aside.
3. Remove the 6 pin-type retainers and the RH splash shield.
4. Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.
5. Remove the 2 bolts and the accessory drive belt tensioner.
^
To install, tighten to 25 Nm (18 lb-ft).
6. To install, reverse the removal procedure.