Fusion FWD L4-2.3L VIN Z (2007)
13. Remove the 4 recliner-to-cushion frame bolts and remove the backrest assembly.
-
Route out the wire harness(es) and manual lumbar cable, if equipped.
-
Note routing for installation.
-
To install, tighten to 55 Nm (41 lb-ft).
14. To install, reverse the removal procedure.
15. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
16. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
Seat Backrest - Front, With Fold Flat
SEAT BACKREST - FRONT, WITH FOLD FLAT