Fusion FWD L4-2.3L VIN Z (2007)
3. Remove the 2 nuts and detach the latch release handle bracket.
4. Detach the 2 pin-type retainers and latch cable assembly.
-
Note the cable routing for installation.
5. Detach the release cable from the latch and remove.
6. Remove the backrest latch.
-
Remove the 2 nuts and backrest latch.
Installation
1. Position the backrest latch to the 2 studs.
2. Install the 2 latch nuts and hand tighten.
3. Attach the release cable to the latch.
4. Route the release cable, position the release handle and bracket to the 2 studs and install the 2 nuts.
-
To install, tighten to 12 Nm (9 lb-ft).
1
Install the 2 release cable pin-type retainers.
-
Position the trim and install the pin-type retainer.
5. Adjust the latch position as necessary for good backrest fit and latch closure when upright.
-
Tighten to 48 Nm (35 lb-ft).
6. Install the parcel shelf.
-
Verify the safety belt retractor operates without excessive effort or binding.