Fusion FWD L4-2.3L VIN Z (2007)
2. CAUTION: Only hand-tighten the 6 mm (0.23 inch) bolt or damage to the front cover can occur.
NOTE: This step will correctly align the crankshaft pulley to the crankshaft.
Install a standard 6 mm (0.23 inch) x 18 mm (0.7 inch) bolt through the crankshaft pulley and thread it into the front cover.
3. Assemble the special tools using 4 hardened washers in the locations shown.
4. CAUTION: The crankshaft must remain in the TDC position during installation of the pulley bolt or damage to the engine can occur. Therefore,
the crankshaft pulley must be held in place with the special tool and the bolt should be installed using hand tools only.
CAUTION: Do not reuse the crankshaft pulley bolt.