Fusion FWD L4-2.3L VIN Z (2007)
10. NOTE: Whenever the crankshaft position (CKP) sensor is removed, a new one must be installed using the alignment tool supplied with the new
part.
Install a new CKP sensor.
^
Do not tighten the bolts at this time.
11. NOTE: The CKP sensor alignment tool is supplied with the new sensor and is not available separately.
Adjust the new CKP sensor with the alignment tool.
^
Tighten the bolts to 7 Nm (62 inch lbs.).
12. Connect the CKP sensor electrical connector.
13. Remove the 6 mm (0.23 inch) x 18 mm (0.7 inch) bolt.
14. If equipped, install the underbody cover and the 7 screws.