Fusion FWD L4-2.3L VIN Z (2007)
-
To install, tighten to 15 Nm (11 ft. lbs.).
All engines
16. If equipped, detach the engine block heater harness from the power steering pressure line.
17. Remove the power steering pressure line-to-steering gear banjo bolt and remove the power steering pressure line.
-
Discard the bolt and the 2 seals.
-
To install, tighten to 55 Nm (41 ft. lbs.).
18. CAUTION: New banjo bolts and new seals must be installed any time the power steering pressure line is disconnected from the power steering
pump and/or the power steering gear.
To install, reverse removal procedure.
19. Fill the power steering system.