Fusion FWD L4-2.3L VIN Z (2007)
Side Air Bag: Service and Repair
Side Air Bag Module
SIDE AIR BAG MODULE
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
Carry a live side air bag module with the air bag and tear seam pointed away from your body. This will reduce the risk of injury in the
event of an accidental deployment.
-
Do not set a live side air bag module down on the cover tear seam. This will reduce the risk of injury in the event of an accidental
deployment.
-
After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
Side air bag modules with damaged covers must be replaced.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a side air bag deployment took place, a new side air bag module and bolt must be installed. The side air bag module bracket on the seat back
frame should be inspected and replaced if necessary.
-
If a seat equipped with a SRS component is being serviced, the SRS must be depowered.
-
When replacing the side air bag after deployment, refer to Seats.
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system SRS fault.