Fusion FWD L4-2.3L VIN Z (2007)
Seat Belt Height Adjuster: Service and Repair
SAFETY BELT SHOULDER HEIGHT ADJUSTER
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should
be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. Position the seat to its most FORWARD position.
2. Remove the upper B-pillar trim panel.
3. NOTE: Position the safety belt shoulder height adjuster DOWN to access the bolt.
Remove the bolt.
-
To install, tighten to 40 Nm (30 lb-ft).