Fusion FWD L4-2.3L VIN Z (2007)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear, Front Wheel Drive (FWD)
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the rear seat bolster.
3. Disconnect the wheel speed sensor electrical connector.
4. With the vehicle in NEUTRAL, position it on a hoist.
5. Using a suitable tool, disconnect the grommet from the body.
6. NOTE: It is not necessary to remove the harness routing brackets.
Disconnect the wheel speed sensor harness from the brackets.
7. Remove the wheel speed sensor wire bolt and the wheel speed sensor.
^
To install, tighten to 23 Nm (17 ft. lbs.).
8. To install, reverse the removal procedure.
