Fusion FWD L4-2.3L VIN Z (2007)
All Wheel Drive (AWD) Vehicles
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of
these parts.
CAUTION: Before tightening any suspension bushing fasteners, the suspension must be at the bushing fastener tightening position.
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Using a suitable jack, support the trailing arm.
3. CAUTION: Do not fully tighten the shock absorber lower nut until the suspension is at the bushing fastener tightening position.
Remove and discard the shock absorber lower bolt and flag nut.
-
To install, tighten to 90 Nm (66 ft. lbs.) with the suspension at the bushing fastener tightening position.
Front wheel drive (FWD) vehicles
4. Remove and discard the upper arm outboard bolt.
-
To install, tighten the bolt to 110 Nm (81 ft. lbs.) with the suspension at the bushing fastener tightening position.