Fusion FWD L4-2.3L VIN Z (2007)
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of
these parts.
CAUTION: Before tightening any suspension bushing fasteners, the suspension must be at the bushing fastener tightening position.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. If equipped, remove the wheel speed sensor bolt and position the sensor aside.
-
To install, tighten to 23 Nm (17 ft. lbs.).
3. Disconnect the parking brake cable from the brake caliper.
1. Remove the clip.
2. Disconnect the parking brake cable from the brake caliper.
