Fusion FWD L4-2.5L Hybrid (2010)
Antenna Cable: Service and Repair
Antenna Cable - AM/FM
Antenna Cable - AM/FM
NOTE: Only the front AM/FM antenna cable is shown.
Removal
NOTE: Both the front and rear AM/FM antenna cables are part of the vehicle wiring harness. Because the cables cannot be removed from the harness,
this procedure applies to replacement of the cables only.
Front cable
1. Remove the Audio Control Module (ACM). For additional information, refer to Audio Control Module (ACM) - Fusion, Milan See: Cellular
Phone/Communications Control Module/Service and Repair/Removal and Replacement/Audio Control Module (ACM) or Audio Control Module
(ACM) - MKZ See: Cellular Phone/Communications Control Module/Service and Repair/Removal and Replacement/Audio Control Module
(ACM).
Rear cable
2. Remove the RH front and RH rear sill panels by pulling straight upward.
3. NOTE: For MKZ, it is only necessary to remove the RH C-pillar trim panel.
Remove the LH and RH assist handles, and the LH and RH C-pillar trim panels.
4. NOTE: For Fusion/Milan, it is necessary to loosen the antenna cable bolt.
Disconnect the rear AM/FM antenna cable from the AM/FM antenna (Fusion, Milan) or the antenna module (MKZ).
5. Remove the enable circuit.
1. Disconnect C237 at the RH kick panel.
2. Remove the pin retainer from the inside of the male side of the connector by pulling straight out with pliers.
3. Using a suitable tool such as a straight pick, release the locking tab and remove the enable circuit CME44 (BU) from C237-25.