Fusion FWD L4-2.5L Hybrid (2010)
Parking Assist Control Module: Service and Repair
Parking Aid Module (PAM)
Removal and Installation
1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.
Upload the PAM configuration information to the scan tool. For additional information, refer to PMI in Information Bus. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
2. Remove the LH rear seat bolster. For additional information, refer to Seats.
3. Remove the 2 screws and the PAM.
-
Disconnect the electrical connectors.
4. To install, reverse the removal procedure.
-
Download the PAM configuration information. For additional information, refer to Information Bus.