Fusion FWD L4-2.5L Hybrid (2010)
1. Disengage the lower J-strips.
-
Slide the heat deflector out from between the backrest frame and backrest cover, if equipped.
2. Disengage the 2 J-clips.
3. Disengage the backrest cover clip and unwrap the backrest cover from around the backrest frame.
8. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
backrest foam pad.
Remove the backrest cover.
-
Invert the backrest cover, separate the hook-and-loop strips and remove all rows of hog rings working up the backrest.
9. To install, reverse the removal procedure.
Seat Backrest Cover - Rear, 60 Percent
Seat Backrest Cover - Rear, 60 Percent
Removal and Installation
All vehicles
1. Remove the 60 percent rear seat backrest. For additional information, refer to Seat Backrest - Rear See: Seat Back/Service and Repair/Removal
and Replacement/Seat Backrest - Rear.
2. While lifting up on the head restraint, push in the hole, push in the button and remove the head restraint.
-
Repeat for the other head restraint.
3. Release 4 tabs (2 shown) and remove the striker cover.