Fusion FWD L4-2.5L Hybrid (2010)
2. Install by hand all four seat track-to-floor bolts, then tighten. See Figure 24.
^
Tighten to 47 Nm (35 lb-ft) in the following sequence.
3. Install the four seat track-to-floor bolt covers.
59. Install the head restraint into the head restraint guide sleeves
60. Repower the Supplemental Restraint System (SRS). For additional information, refer to WSM, Section 501-20B, SRS Repowering Procedure.
Attachment V - Driver and Passenger Seat Backrest Frame Replacement
(NEW!) OVERVIEW
Fusion and Milan Passenger Seat Recliner Replacement
Attachment III
Fusion and Milan - Driver Seat Backrest Frame Replacement Attachment IV
Explorer Mountaineer and Sport Trac -
Driver and Passenger Seat Backrest Frame Replacement
Attachment V
SERVICE PROCEDURE - ATTACHMENT V
EXPLORER, MOUNTAINEER AND SPORT TRAC - DRIVER AND PASSENGER SEAT BACKREST FRAME REPLACEMENT
WARNING:
Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors Failure to follow this
instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of
serious personal injury or death
WARNING:
Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules Failure to follow this instruction may result in the
accidental deployment of these modules, which increases the risk of serious personal injury or death.
WARNING:
Use care when handling the front passenger seat and track assembly Dropping the assembly, placing excessive weight on or sitting on a front