Fusion FWD L4-2.5L Hybrid (2010)
1. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Service and Repair.
2. Remove the cooling fan motor and shroud. For additional information, refer to Cooling Fan Motor and Shroud See: Radiator Cooling
Fan/Radiator Cooling Fan Motor/Service and Repair.
3. Disconnect the upper radiator hose from the radiator.
4. Disconnect the radiator-to-degas bottle hose from the radiator.
5. Disconnect the lower radiator hose from the radiator.
6. Remove the A/C tubes retainer bolt.
-
To install, tighten to 7 Nm (62 lb-in).
7. Remove the 2 bolts from the upper radiator support brackets and position the radiator towards the engine and remove the 2 upper radiator support
bracket from the radiator.
-
To install, tighten to 10 Nm (89 lb-in).
8. Remove the A/C condenser-to-radiator pin-type retainer.