Fusion FWD L4-2.5L Hybrid (2010)
10. Detach the 3 wiring retainers from the intake manifold near the throttle body mounting area.
11. Disconnect the auxiliary coolant pump electrical connector and detach the 2 wiring retainers.
12. Detach the lower radiator hose retainer from the intake manifold.
13. Detach the engine wiring harness retainer and the vehicle high voltage electrical system wire retainer from the intake manifold.
14. Disconnect the Knock Sensor (KS) electrical connector and detach the retainer from the intake manifold.
15. Remove the cooling fan motor and shroud. For additional information, refer to Cooling System.
16. Remove the 3 A/C compressor bolts and position the compressor aside.
-
To install, tighten to 25 Nm (18 lb-ft).
17. NOTE: The cylinder head side of the intake manifold is showing the location of the 7 bolts.
Remove the 7 bolts and position the intake manifold aside to access the PCV hose connector.
-
To install, tighten to 18 Nm (159 lb-in).
18. Squeeze the 2 PCV hose connector tabs and disconnect the PCV hose from the intake manifold.
19. Remove the intake manifold and gaskets.
20. NOTICE: If the engine is repaired or replaced because of upper engine failure, typically including valve or piston damage, check the
intake manifold for metal debris. If metal debris is found, install a new intake manifold. Failure to follow these instructions can result in
engine damage.
To install, reverse the removal procedure.
-
Inspect and install new intake manifold gaskets if necessary.