Fusion FWD L4-2.5L Hybrid (2010)
8. Install the engine mount. For additional information, refer to Engine Mount See: Drive Belts, Mounts, Brackets and Accessories/Engine
Mount/Service and Repair/Removal and Replacement.
9. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley See: Cylinder Block Assembly/Harmonic Balancer -
Crankshaft Pulley/Service and Repair/Crankshaft Pulley.
10. NOTICE: Only hand-tighten the bolt or damage to the front cover can occur.
Install a standard 6 mm (0.23 in) x 18 mm (0.7 in) bolt through the crankshaft pulley and thread it into the front cover.
11. Install the CKP sensor and the 2 bolts.
-
Do not tighten the bolts at this time.
12. Using the Crankshaft Sensor Aligner, adjust the CKP sensor.
-
Tighten the 2 CKP bolts to 7 Nm (62 lb-in).
13. Connect the CKP sensor electrical connector.
14. Remove the 6 mm x 18 mm bolt.
15. Install the accessory drive belt and tensioner. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
16. Repower the vehicle high voltage electrical system. For additional information, refer to Hybrid Drive Systems.
