Fusion FWD L4-2.5L Hybrid (2010)
Catalytic Converter: Service and Repair
Catalytic Converter - Underbody
Catalytic Converter - Underbody
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove and discard the 2 exhaust flexible pipe-to-catalytic converter nuts.
-
Discard the gasket.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the Torca(R) clamp. For additional information, refer to Torca(R) Clamp See: Service and Repair/Torca(R) Clamp.
4. Separate the catalytic converter from the muffler and tail pipe.
-
Remove the catalytic converter.
5. To install, reverse the removal procedure.
-
Install a new gasket and nuts.
6. Start the engine and check for exhaust leaks.