Fusion FWD L4-2.5L Hybrid (2010)
Headlamp Control Module: Service and Repair
Headlamp Control Module (HCM)
Removal and Installation
1. If installing a new Headlamp Control Module (HCM), upload the module configuration information to the scan tool. For additional information,
refer to Information Bus.
2. Disconnect the HCM electrical connector.
3. Remove the 2 pin-type retainers and the HCM.
4. To install, reverse the removal procedure.
-
If installing a new HCM, download the HCM configuration information from the scan tool into the new HCM. For additional information,
refer to Programmable Module Installation (PMI)
Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning