Fusion FWD L4-2.5L Hybrid (2010)
-
Disconnect the APIM electrical connector.
-
Disconnect the Universal Serial Bus (USB) cable.
5. To install, reverse the removal procedure.
-
If a new APIM is being installed, program the APIM to the correct software level. For additional information, refer to Accessory Protocol
Interface Module (APIM) Programming in Information Bus. See: Powertrain Management/Computers and Control Systems/Information
Bus/Testing and Inspection/Programming and Relearning/Accessory Protocol Interface Module (APIM) Programming Using The Integrated
Diagnostic System (IDS)