Fusion FWD L4-2.5L Hybrid (2010)
16. Install the ACL assembly. For additional information, refer to
Fuel Delivery and Air Induction.
17. Fill the transaxle with clean transmission fluid.
18. If a new solenoid body is installed, the solenoid body strategy and solenoid body identification will need to be updated. For additional
Information, refer to Solenoid Body Strategy See: Transmission Control Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/6F35/Solenoid Body Strategy
19. If a replacement transaxle assembly is being installed or a new solenoid body is installed, the PCM will have to be reflashed with a new solenoid
body strategy and identification data file. For additional information, refer to Solenoid Body Strategy See: Transmission Control Systems/Testing
and Inspection/Initial Inspection and Diagnostic Overview/6F35/Solenoid Body Strategy.
20. Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure
that the transmission fluid is at the correct level.
Solenoid Body Assembly
Solenoid Body Assembly