Fusion FWD L4-2.5L Hybrid (2010)
Transmission Speed Sensor: Service and Repair
Vehicle Speed Sensor (VSS)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Disconnect the Vehicle Speed Sensor (VSS) electrical connector.
3. Remove the VSS bolt.
-
To install, tighten to 9 Nm (80 lb-in).
4. Remove the VSS.
-
Discard the O-ring.
5. To install, reverse the removal procedure.
-
Apply clean manual transaxle fluid to a new O-ring and install it on the VSS.
