Fusion FWD V6-3.0L (2009)
7. Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.
Programming the Auto-Unlock Feature Using the Keyless Entry Keypad
NOTE: The horn chirp is not programmable, but is used to verify the programming mode is entered and if the feature has been enabled or disabled.
NOTE: The autolock and auto-unlock features can also be enabled or disabled with the scan tool. For additional information on module configuration,
refer to Information Bus.
NOTE: The auto-unlock feature is disabled on vehicles equipped with a manual transaxle.
NOTE: The auto-unlock feature can be enabled or disabled independently of the autolock feature.
NOTE: Make sure that the vehicle's perimeter alarm is not armed, the key is in the OFF position and the doors are closed.
NOTE: The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait
30 seconds between programming sessions.
1. Turn the ignition key to the OFF position.
2. Close all of the doors.
3. Enter the factory set 5 digit entry code.
4. Press and hold the 3/4 button. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button, press and release
the 7/8 button a second time.
5. Release the 3/4 button. The horn chirps once if auto-unlock is disabled, or chirps once followed by a honk if auto-unlock is enabled.
Remote Memory Activation
Remote Memory Activation
1. Position the driver seat and exterior mirror(s) to the desired positions.
2. Press and hold either memory button (1 or 2) for 5 seconds. A tone will be heard after 1-1/2 seconds when the memory store is done. Continue to
hold until a second tone is heard after 5 seconds.
3. Within 3 seconds, press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
4. If a second memory setting is desired, repeat the procedure with the second RKE transmitter.
Remote Memory Deactivation
Remote Memory Deactivation
1. Press and hold either memory button (1 or 2) for 5 seconds. A tone will be heard after 1-1/2 seconds when the memory store is done. Continue to
hold until a second tone is heard after 5 seconds.
2. Within 3 seconds, press the UNLOCK button on the Remote Keyless Entry (RKE) transmitter.
3. If a second memory setting is desired to be deactivated, repeat the procedure with the second RKE transmitter.
Perimeter Lighting Feature Programming
Perimeter Lighting Feature Programming
Programming the Perimeter Lighting Feature Using the Door Lock Control Switch
NOTE: The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait
30 seconds between programming sessions.
1. Turn the ignition switch from the OFF to the ON position.
