Fusion FWD V6-3.0L (2009)
Garage Door Opener Transmitter: Programming and Relearning
Universal Transmitter Programming
NOTE: A new battery in the hand-held transmitter may allow quicker and easier training due to a more accurate transmission of the radio frequency
signal.
1. Verify the hand-held transmitter is operative.
2. Prepare for programming the universal transmitter by erasing all 3 channels by holding down the 2 outside buttons until the red light begins to
flash (20-30 seconds). Release both buttons.
3. Select 1 of the 3 universal transmitter channels to be used for programming.
4. Hold the end of the hand-held transmitter 25-51 mm (1-2 in) from the front surface of the universal transmitter so that the red light can still be
seen.
5. NOTE: During programming, the hand-held transmitter may automatically stop transmitting after 2 seconds, which may not be long enough to
program the universal transmitter. If programming this type of hand-held transmitter, continue to hold the button on the universal transmitter while
pressing the hand-held transmitter button every 2 seconds.
At the same time, press the hand-held transmitter button and the desired button on the universal transmitter until the red light on the universal
transmitter flashes first slowly, and then rapidly. Release both buttons when the rapid flashing begins.
6. Firmly press and hold for 5 seconds and release the programmed hand-held transmitter button up to 2 separate times to activate the door. If the
door does not activate, press and hold the just-trained universal transmitter button and observe the indicator light.
-
If the indicator light stays on constantly, the programming is complete and the device should activate when the universal transmitter button is
pressed and released.
-
If the indicator light blinks rapidly for 2 seconds and then turns to a constant light, follow the Training a Garage Door Opener Equipped With
"Rolling Codes " procedure below to complete the programming of a rolling code equipped device (most commonly a garage door opener).
7. To program additional hand-held transmitters repeat Steps 3-6.
Training a Garage Door Opener Equipped With "Rolling Codes"
1. NOTE: Step 3 must be initiated within 30 seconds of pressing and releasing of the "learn or "smart" button.
At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button. This can usually be found where the
hanging antenna wire is attached to the motor-head unit.
2. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer). There are 30 seconds to
initiate step 3.
3. Return to the vehicle and firmly press, hold for 2 seconds and release the programmed universal transmitter button. Repeat the press/hold/release
sequence a second time and depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third
time to complete the programming process.