Fusion FWD V6-3.0L (2009)
Air Door Actuator / Motor: Service and Repair
Temperature Blend Door Actuator - RH, Dual-Zone EATC
Temperature Blend Door Actuator - RH, Dual-Zone EATC
Removal and Installation
1. Remove the passenger air bag module. For additional information, refer to Air Bag Systems.
2. Disconnect the RH temperature blend door actuator electrical connector.
3. Remove the 2 RH temperature blend door actuator bracket screws.
4. Detach the wire harness from the RH temperature blend door actuator bracket.
5. Remove the RH temperature blend door actuator.
6. To install, reverse the removal procedure.