Fusion FWD V6-3.0L (2009)
The Medium Speed Controller Area Network (MS-CAN) uses an unshielded twisted pair cable, circuits VDB06 (GY/OG) and VDB07 (VT/OG).
This pinpoint test is intended to diagnose the following:
-
Wiring, terminals or connectors
-
Smart Junction Box (SJB)
-
Instrument Cluster (IC)
-
Accessory Protocol Interface Module (APIM) (if equipped)
-
Audio Control Module (ACM)
-
Audio Digital Signal Processing (DSP) module (if equipped)
-
HVAC module (if equipped)
-
Parking Aid Module (PAM) (if equipped)
-
Driver Door Module (DDM) (if equipped)
-
Driver Seat Module (DSM) (if equipped)
-
Dual Climate Controlled Seat Module (DCSM) (if equipped)
-
Satellite Digital Audio Receiver System (SDARS) module (if equipped)
PINPOINT TEST R: NO MS-CAN COMMUNICATION, ALL MODULES ARE NOT RESPONDING
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
R1 CHECK THE DLC PINS FOR DAMAGE
NOTE: Most faults are due to connector and/or wiring concerns. Carry out a thorough inspection and verification before proceeding with the pinpoint
test.
-
Ignition OFF.
-
Disconnect the scan tool cable from the Data Link Connector (DLC).
-
Inspect DLC pins 3 and 11 for damage.
-
Are DLC pins 3 and 11 OK?
Yes
GO to R2.
No
REPAIR the DLC as necessary. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
R2 CHECK THE MS-CAN TERMINATION RESISTANCE
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.
-
Is the resistance between 54 and 66 ohms?
